Mixing
How to high-pass a track without removing its body
Find the lowest useful note, compare cutoff and slope, and decide whether rumble needs a filter or a local edit.
Use a high-pass filter when unwanted low-frequency content is the problem. For broad excess warmth, compare a low shelf; for a single microphone bump, try a local edit. A high-pass cut affects wanted notes in its transition region too, so the source’s lowest useful note should set the listening test.
By Spectraforge Audio2 min read
Published
Guide review: Captum Records and AS Mastering. AI-assisted writing and source checks. How these guides are made.
Filter unwanted lows, not every track
On an acoustic guitar, include a low chord, a light strum and a pause. Listen once with the bass playing and once during a bass rest. The rest exposes whether the guitar still supplies its own weight or depends on another instrument to cover an excessive cut.
Run a cutoff-and-slope comparison
Save the unfiltered sound. Start with a low cutoff and raise it until the rumble recedes, then compare a gentler and steeper slope. Readjust cutoff for each slope: equal frequency numbers do not make the transitions equivalent. Match playback level after the EQ and switch at the same chord.
Pro-Q’s low-cut audition plays the removed range. Use it briefly to identify what the filter rejects, then return to normal playback. Hearing a recognizable note there is a reason to check the final balance, not an automatic ban on filtering.
- Rumble is reduced and the lowest chord remains grounded: test the setting through the full part.
- The low chord becomes weak while bright strums still sound fine: lower the cutoff, soften the slope or compare a shelf.
- Only one pause contains a thump: repair that event before filtering the whole performance.
Check the sum when microphones share a source
After filtering one microphone in a multi-microphone recording, replay it with the other microphones. Frequency-dependent phase changes can alter their blend even when the filtered mic sounds good alone. Listen to the combined low note and attack before adding corrective boosts elsewhere.
Likewise, bypass several track cuts together after cleaning a group. If the whole chorus loses weight, restore useful body at its source. That is easier to judge than compensating for accumulated cuts with a large mix-bus boost.
Separate source trouble from room trouble
If unrelated reference tracks have the same apparent bass excess, or it changes when you move your head, check monitoring before changing all the tracks. Genelec’s room guidance explains why playback response can mislead these decisions. A familiar second system provides another observation, rather than a new absolute reference.
Finish with the lowest notes, exposed pauses and busiest section. Recheck downstream compression or saturation after a substantial cut because their input has changed. Keep the filter only if the unwanted movement recedes without removing the part’s musical foundation.
Technical references
- FabFilter Pro-Q 4: Low-cut shapes and slopes
- FabFilter Pro-Q 4: Auditioning removed frequencies
- FabFilter Pro-Q 4: Filter phase and processing modes
- Genelec: Monitoring response and room influences
Listening exercises are proposed practice routines. Worked examples illustrate the stated setup; they are not reports of our listening tests. Editorial process and corrections.