Spectraforge Audio

Mastering & delivery

Sample rate and bit depth: choosing an audio export format

Choose WAV export settings for mastering, collaboration and release without unnecessary conversions or lost alignment.

For an audio handoff, ask for the sample rate, sample format and channel layout. If there is no requirement to change rate, keeping the project’s rate avoids an unnecessary conversion. Use a lossless file for further production work; make compressed listening previews separately.

By Spectraforge Audio2 min read
Published

Guide review: Captum Records and AS Mastering. AI-assisted writing and source checks. How these guides are made.

Preserve the project rate unless the destination asks otherwise

Sample rate is samples per second. Bit depth concerns amplitude representation. Exporting a lower-rate recording at 96 kHz does not recover detail it never captured. Choosing more bits does not undo a clipped recording. Treat format as a delivery decision, not a way to upgrade the mix.

Choose the representation for the next job

A 24-bit integer WAV is a common production exchange when the receiver accepts it. A 32-bit float WAV is useful for further work when explicitly supported: values above integer full scale can be retained and attenuated in compatible software. That does not repair analogue overload or distortion already created inside a plugin.

For a final 16-bit integer delivery, make the bit-depth reduction deliberately and assign one final stage to dither. For a file going to mastering, agree a higher-precision format and avoid final noise-shaped dither intended for a finished low-bit-depth release. The separate dither guide covers the signal-flow decision.

Worked handoff example: a 48 kHz session going to another producer

Suppose the recipient requests stereo 48 kHz, 24-bit WAV with the approved bus processing. Export that format at the shared start, include the full ending, and disable normalisation if they need the existing mix level. Do not convert to 96 kHz merely to make the file look more substantial.

If they instead request 44.1 kHz for their next stage, export or convert once through a known process, then inspect that converted file. Ableton’s manual describes its rate-conversion and PCM export options; other hosts may perform the steps differently. The destination file, rather than the session meter, is what you must verify.

Verify the file before sending it

Re-import the WAV into a clean session. Inspect its actual rate, sample representation, channels and duration. Listen to the first pickup, loudest section and final decay. Ensure no master processing is applied a second time during this check.

A useful delivery note could read: “Mix03, stereo 48 kHz/24-bit WAV, creative bus compressor included, final loudness limiter removed, no normalisation.” Keep the production export separate from MP3 previews and keep the session that made it. If the recipient can identify the correct revision and import it without guessing, the format has done its job.

Technical references

Listening exercises are proposed practice routines. Worked examples illustrate the stated setup; they are not reports of our listening tests. Editorial process and corrections.

Help

Spectraforge Audio support

Send us a message and we’ll reply by email. Zoho Desk handles your message and any attachments. Privacy policy

Form not loading? Email info@spectraforgeaudio.com.

Your privacy choices

With your permission, Google Analytics measures site use and Meta measures advertising performance. Both are optional. Privacy policy

Privacy settings

Choose which optional tools can run. Your purchases and licence access work with both turned off.