Spectraforge Audio

Mastering & delivery

Why your limiter pumps or distorts, and how to fix the cause

Trace limiter problems to the driving signal, gain reduction and timing before sacrificing the mix for more loudness.

If a limiter pumps or distorts unexpectedly, save its current state, reduce the input drive and compare at matched playback loudness. If the problem disappears, the amount of reduction is part of the cause. A release adjustment may improve the compromise, but it cannot guarantee the same loudness with no cost.

By Spectraforge Audio3 min read
Published

Guide review: Captum Records and AS Mastering. AI-assisted writing and source checks. How these guides are made.

Reduce drive first, then identify the remaining symptom

Name what remains. Pumping is the background level ducking and recovering around an event. Distortion is a changed texture, such as buzzing bass or splattery attacks. They can occur together. Locate the exact bar where the change becomes objectionable before adjusting a whole song’s settings.

Find what holds the limiter down

Loop the problem and watch gain reduction while listening. In a diagnostic copy, briefly mute the kick, bass, snare and transition effects one at a time. A steadier background with one source removed makes that source worth inspecting; it is not proof that the instrument is artistically too loud.

Suggested example: a long bass note overlaps a crash and makes the vocal dip through the next phrase. Try a small bass-envelope or level correction in the copy, then restore the full arrangement and compare at equal loudness. If this preserves the groove better than global limiting, keep the source correction. If it weakens the note’s role, reject it.

Adjust recovery and lookahead as separate controls

Listen between the triggering hits. A release that holds reduction into the next syllable can make the groove drag; rapid recovery may roughen sustained bass. Change one control and compare the same event plus a sparse section. Return to the saved state when a cleaner attack introduces a worse sustain.

Read the limiter’s definitions. Pro-L 2 has an initial lookahead-driven transient stage and a slower release-envelope stage; its Attack control is not a general promise to let peaks pass through as a compressor might. FabFilter documents distortion tradeoffs at very short lookahead. Avoid transferring a favourite compressor timing recipe blindly.

Use linking and oversampling only for the problem they address

If a left-side crash pulls the centre down, inspect the limiter’s stereo linking. Compare a modest change while listening to the centred vocal. Reject a setting that cures the dip by making the stereo image move. Different limiters expose different transient and sustained linking controls.

Oversampling may reduce aliasing from the limiting process, but it does not repair an excessive envelope change. Select the intended mode, allow compensation to update and compare. If lowering drive is still the only acceptable result, revise the source balance or accept a less dense master.

Verify the revised master

Export with the intended ceiling and quality mode, then remeasure the finished file’s true peak. Listen across every loud transition and compare with the old version at matched level. Check that a source correction did not fix the chorus while leaving a verse unnaturally quiet.

A limiter cannot restore upstream clipping. If the roughness is present with the limiter removed, follow the signal back to the stage that created it. Stop when the entire master recovers naturally, keeps its intended impact and meets the actual delivery specification.

Technical references

Listening exercises are proposed practice routines. Worked examples illustrate the stated setup; they are not reports of our listening tests. Editorial process and corrections.

Help

Spectraforge Audio support

Send us a message and we’ll reply by email. Zoho Desk handles your message and any attachments. Privacy policy

Form not loading? Email info@spectraforgeaudio.com.

Your privacy choices

With your permission, Google Analytics measures site use and Meta measures advertising performance. Both are optional. Privacy policy

Privacy settings

Choose which optional tools can run. Your purchases and licence access work with both turned off.